Euroclean Back Vac 6 Spécifications télécharger pdf (Page 16)

GENERAL INSTRUCTION FOR USE

Numbered sections below correspond to numbered photos on pages 4-12

1. General overview of equipment:

Accessories shown in the illustrations may vary from model to

model.

2. Hose connection:

Fit the hose inlet sleeve into the opening on the upper lid.

Apply soft pressure and turn the inlet sleeve approximately

half a turn to ensure it is firmly secured. Turn clockwise to

lock, counterclockwise to release.

3. Adjustment of strap position on support plate:

On the primary strap, the position of the strap can be

adjusted for your individual comfort by moving the

adjustment plate to the inner or outer position.

4. Adjustment of tension ties on the strap’s support

plate:

You can adjust the tension ties for your individual comfort.

Form a loop with your finger, then move the tie through the

clip forwards or backwards to the required length. Remove

your finger. Tension the tie.

5. Adjusting the vacuum cleaner to sit comfortably on

your back:

Pick up the vacuum cleaner. Put your arms through the

shoulder straps. Snap the waistbelt clip shut. Adjust

the length. Snap the chest clip shut. Adjust the straps

vertically by pulling down on both ties as shown in the

picture.

6. Tension tie clip:

Snap the two halves of the clip together. Make sure they

are securely fastened. To unlock, press both sides of the

clip simultaneously.

7. Cord set:

This vacuum cleaner is equipped with a 50 ft extension

power cord, of type 3x16AWG, 125V, SJT, SJO, that

must be connected to the cord set from the machine.

Always use and connect such an extension cord to

this vacuum cleaner. Place the end of the extension

cord in to the snap hook from the vacuum cleaner in

order to create a cord relieve by the hook. When cleaning

is performed roll up the extension cord starting at the

machine end and store it at the machine belt by

snapping the nylon strap around the cord.

8. Cord Relief:

Connect the extension cord to the outlet from the cleaner.

Place the end of the extension cord in to the snap hook

that is placed at the vacuum cleaner in order to create a

Cord Relief by the hook. Make sure the cord is properly

secured in the hook.

9. On/Off:

The on/off switch is located in a separate housing attached

to the right side of the waistbelt. Tilt the switch for ON or

OFF function.

10. Dust bag:

If the suction power diminishes, it may be time to replace

the dust bag. Check the bag frequently to make sure that

you don’t overfill. Release the latches on the upper lid.

Lift up the lid from the container. Grasp at the cardboard

part of the dust bag and carefully lift the bag out of the

container. Some types of dust bag can be sealed to

prevent any dust/rubbish from being released.

In that case, peel off the protective paper and fold the

cardboard collar to seal the bag.

11. Main filter:

When you replace the dustbag also replace or clean the

Main filter. This can be done after you have lifted out the

dust bag. Clean the filter by shaking it well. Reinstall the

filter into the machine or replace it with a new one if it

can not be cleaned. Replace the dust bag and slide it in

place to the main filter. Then put back the lid and close the

latches.

12. HEPA filter:

HEPA filters cannot be cleaned or washed. Once they

have become dirty, they must be replaced. Check and

change the HEPA filter frequently. When handling a new

HEPA filter, avoid touching the surface of the filter. Take

hold of the plastic framework instead to insure the HEPA

filter functions properly. To replace the HEPA filter: Unlock

the lower set of latches that secure the motor base to

container. Lift off the container and lid assembly. Turn the

HEPA filter counterclockwise and lift filter directly upward

to remove. Repeat in reverse order to install new HEPA

filter.

13. Pre-filter:

Check the pre-filter frequently. Never run the vacuum

cleaner without the pre-filter in place. Once the HEPA

filter is removed (see Section 12 above) it is possible to

inspect and replace the pre-filter if needed. Release the

two latches on the motor top. Remove the container and

the upper lid. Place the pre-filter in the center of the motor

top. Lock both latches down.

14. Exhaust filter:

This filter is used to clean the exhaust air coming from the

motor. To replace exhaust filter: press down on the center

tab of the exhaust cover and pull outward to remove the

cover from machine. Place a new exhaust filter into the

cover and replace the cover onto the machine.

15. Power Nozzle:

Always turn off the vacuum cleaner before connecting or

disconnecting motorized nozzle. Plug the cord of the nozzle

into the socket outlet on the side of the machine. The

power outlet for the Power Nozzle is only available on

some models.

16. Connection of hose and tube end:

Connect the hose sleeve and the bent tube end by

pushing the bent end into the hose sleeve.

17. Extension tubes:

Fit the to tubes together and secure them by pressing

down the knob. Make sure the knob is securing the two

tubes.

18. Scallop nozzle:

Brush floor nozzle for both hard floors and carpets. Fit the

nozzle to the tube end coupling. Secure and fasten the

nozzle by turning the nut at the tube to the right. To unlock

- turn the nut to the left.

19. Brush nozzle:

Useful tool for cleaning furnishings etc. Fit the nozzle to

the tube end coupling. Secure the nozzle by turning the

nut at the tube to the right. To unlock - turn the nut to the

left.

20. Crevice nozzle:

For cleaning tight spaces such as furniture, radiators and

corners. Secure the nozzle by turning the nut at the tube to

the right.

823 0100 050 Instruction for use Euroclean Back Vac 6 Back Vac 10.indd 16823 0100 050 Instruction for use Euroclean Back Vac 6 Back Vac 10.indd 16 2008-02-25 14:39:252008-02-25 14:39:25

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Euroclean Back Vac 6 Spécifications Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs Euroclean Back Vac 6